Cold pressed insulator introduction

Cold pressed insulator introduction shared by Composite Insulator supplier.

Insulation terminal is also known as cold pressure end, electronic connector, air connector are attributed to cold pressure end. Is used to achieve electrical connection of a kind of accessories products, industry is divided into the category of connectors. With the increasing degree of industrial automation and industrial control requirements are more and more strict and accurate, the use of terminals gradually increases. With the development of the electronic industry, more and more terminals are used, and more and more kinds are used. At present, in addition to PCB board terminal, there are hardware continuous terminal, nut terminal, spring terminal and so on.

Fuse Cutout

Concept

Insulation terminal is also known as cold pressure end, such as the Porcelain Pin Insulators, electronic connector, air connector are attributed to cold pressure end. Is used to achieve electrical connection of a kind of accessories products, industry is divided into the category of connectors. With the increasing degree of industrial automation and industrial control requirements are more and more strict and accurate, the use of terminals gradually increases. With the development of the electronic industry, more and more terminals are used, and more and more kinds are used. At present, in addition to PCB board terminal, there are hardware continuous terminal, nut terminal, spring terminal and so on.

Circular pre insulated end, cold-press terminal stud, forked end of needle, the insulation insulation end, piece form insulation end, bullet fully insulated terminal head, elongated middle joint, short end of the middle joint, round naked, bare forked end of male female, insulated terminals, tubular insulation end naked, bare tube end, needle end.